Tonebender II Professional (or Marshall Supa-Fuzz) with
- Bass,
- Middle Contour,
- High ,
- Low Battery,
- Gate DIP switches.
- Rangemaster and a Fuzz Face in the same box, or
- Switchable Tonebender II Professional/Fuzz Face
- $15 for Ready-to-Solder PCB, plus Shipping and Handling.
A 50k "Bias" pot or switched 47k resistor on the input works well with the TB2.
Bass gives you a bass boost, Treble a treble cut, and Mid gives a midrange boost. Something for
everyone
If you put in a larger low battery resistor it oscillates, which you may prefer. The Gate switch
makes the signal cut out after a few seconds, which you may prefer.
The PCB uses a 6 or 8-pin DIP switch. You can some or all of the dip switches with external
switches or pots, or jumper them permanently. It uses a 10k preset in place of the 8.2k resistor to
set the collector bias at 4.5V. It measures 1.5 inches by 2 inches.
1. Orange Squeezer Compressor Pho...
